After starting the granulator, pour the mixed material into the bucket, and then use the swinging action of the rotating drum, the material will form particles after passing through the wire screen, which will fall into the packaged container, for example, to be crushed If the lumps are added, they should be added gradually. Do not fill up too much at once to avoid excessive pressure, which will easily damage the wire screen. If the powder inside the powder hopper is not in front of the top, it cannot be directly removed by hand. In order to avoid accidents, you should use the bamboo chip factory or the top machinery to work the pellet machine. The box part of the pellet machine should be installed with an oil meter. . The temperature rise and the operating conditions are gradually added, and the turbine box must store the oil for a long time, and the height of the oil level is the standard for the turbine to enter the oil.
If you use the pellet machine frequently, you need to change to a new oil every three months. An oil plug is installed at the bottom of the pellet machine to drain the oil. Before the pellet machine is refueled, the oil cannot spill out of the cup, let alone flow. To the surrounding of the pellet machine or on the floor, because oily substances are very easy to contaminate the material, which seriously affects the quality of the product. If the pellets are used for a long time, you must pay attention to maintenance problems. You need to check the tendons regularly every one month. Check the bolts, worm rods, turbine bearings and other parts on the slider at a time. Whether it rotates flexibly and whether there is serious wear and tear, if defects are found, timely repair is required. The pellet machine cannot be used continuously, and it must be used in a dry room. The environment must not contain acidic substances and cause damage to the body. Used in places where corrosive gas circulates.
After the pellet machine is used or stopped, the rotating drum should be taken out to clean and brush the remaining powder in the bucket, and then install it, ready for the next use. When the roller moves back and forth during work, please adjust the screw on the front bearing to the proper position. Turn the pulley by hand, and the tightness is appropriate. Too tight or too loose can cause damage to the pellet machine. If the machine is out of service for a long time, the whole body of the machine needs to be cleaned, and the smooth surface of the machine parts should be coated with anti-rust oil and covered with a cloth hood.
The pellet machine is packaged as a whole, unpacked and moved to a suitable place for use, and can be used after being leveled. Pay attention to the direction of rotation and do not reverse it, because one end of the worm has a flat ball bearing, and the direction of the force must be on the bearing, otherwise the damage at the other end of the worm will heat up and affect the service life of the pellet machine.