The biomass pellet machine can only meet the production requirements under normal production conditions. Therefore, every aspect of it needs to be carefully maintained. If the biomass pellet machine is well maintained, it can operate normally. Today we are mainly going to understand what management can be carried out by the biomass pellet machine to ensure the stable operation of the equipment?
The biomass pellet machine manages the feed inlet, and different biomass materials should be stored in independent warehouses and special places to prevent inflammable and explosive materials, open flames, and indicate the name of the raw material, the environmental humidity and the time of purchase. The person in charge of the warehouse of the biomass pellet machine production line should unify the number of the feed inlet of the pelletizer and draw a detailed distribution of the storage yard area, and then notify the laboratory, the operator, the machine and equipment supervisor and the feed inlet respectively, and Cooperate with the above-mentioned personnel. Clarify the incoming slogan and the storage status of each raw material.
Improve the management methods of materials, smoke and dust, each air inlet should be marked with the name of the raw material stored by the biomass pellet machine and the environmental humidity; each entrance of the pellet mill should be marked with the same logo as the cooler and vibrating screen Specification model and serial number, etc. Each pellet production line should be managed by full-time personnel. When biomass fuel materials enter the warehouse, the material receiver and supplier personnel should check and sign for confirmation to prevent errors in the feeding process and damage production. The warehouse manager of the granulator production line solved the problem of unifying the raw material entrance serial number and assigning the entrance, and notified the laboratory and control system supervisor.
Regularly maintain whether the components are working properly and check once a month. The inspection includes whether the worm gear, worm, anchor bolts and bearings on the lubrication block are normal, and the turning does not damage the agility. If all defects are found, they should be repaired immediately and no longer used.
After using the biomass pellet machine or when it is terminated, the drum should be removed to clean and remove the remaining powder in the barrel (only applicable to some powder pellet machines), and then install it correctly to prepare for the next use in advance.
When the roller moves back and forth during operation, the M10 screw on the front bearing pawl should be adjusted to an appropriate position. If the shaft sleeve moves, please adjust the M10 screw on the back of the bearing frame to a suitable position, adjust the gap so that the bearing does not make noise, rotate the pulley forcefully and tighten it appropriately. If it is too tight or too loose, it may damage the device. If the equipment stops using the biomass pellet machine for a long time, the entire biomass pellet machine device must be scrubbed and cleaned, and the smooth surface of the equipment parts must be coated with rust inhibitor and covered with a cloth.