To make fuel particles is not to say that it is good, the key is that it is more suitable for you. At present, to do fuel particles technology is also mature belongs to the flat mold granulator. The following is the difference between flat die and ring die, for reference only:
1、 Feeding mode: the ring mold briquetting machine adopts the curve feeding groove to compress the feeding, and the high-speed rotation point-to-point enters the compression bin, that is, the raw material is sent to the pressing wheel, and the feeding is not uniform up and down due to the weight of the material itself; The flat mold granulator is based on the weight of the material itself to enter the pressing chamber vertically, which can feed evenly. 2、 Pressure: any briquetting machine for biomass compression, only in 1-2.5 mm gap can be compressed into blocks, gap is large, often can not be compressed into blocks, and ring mold briquetting machine adjustment gap between 0-8 mm, not limited by the mold diameter, so there is no gap can not be adjusted; The diameter of the flat die roller is not limited by the diameter of the die. The bearing space can be increased. The bearing capacity of the roller can be enhanced by selecting large-sized bearing, which not only improves the pressing force of the roller, but also prolongs its service life. 3、 Discharge mode: the ring mold is of high speed, and the damage rate is high when the material is discharged; The flat die has low speed and low damage rate（ When the density is reached, the block finished product comes out. The damage degree has nothing to do with the discharging speed, at most it has to do with the height of the receiving plane.)
4、 Press wheel adjustment mode: the ring mold press block machine uses two screws on the eccentric wheel in the middle of the press wheel to adjust the clearance of the press wheel module to control the pressure, which is convenient and fast; Flat mold granulator is a screw thread M100 center adjustment mechanism, with a jacking force of 100 tons, stable falling, soft impact and even pressure. It can be adjusted by manual rotation and automatic hydraulic pressure. 5、 Compression molding diversification, round bar, block, particle replacement mold can be done to adapt to different materials compression molding, to achieve the best benefits