The granulator is composed of extrusion system software, transmission device and heating and cooling system. According to the material flow direction of the engine and the intersection angle of the screw axis of the extruder, all the engines of the flame retardant plastic machine are divided into inclined angle engines and inclined angle engines.
1. At the beginning, the granulator should be installed in the place of natural ventilation to ensure that the motor can release the heat very well during the work, so as to increase the service life of its application.
2. Be sure to fill the rolling bearing with a little grease on time, so as to ensure the wettability between the rolling bearings.
3. It is necessary to regularly check the props and screws inside. If it is a newly upgraded granulator, it can use some special tools to tighten the Livingston of the cutter and the fixed cutter on the whole body after one hour of application, and improve the variability between the cutter head and the knife table.
4. Before the secondary operation, the actual operator should first eliminate some leftover materials in the machine room, so as to reduce the friction resistance.
5. It is necessary to open the wheel of inertia force cover and drive belt on time, and make clear the ash area under the flange plate. It is considered that when the granulator discharges the granular material, it is very easy for the granular material to penetrate into the rolling bearing of drive shaft.
6. The granulator should maintain a stable grounding device.